Header Ads

How to Operate iStick TC100W Mod

How to Use
Power on/off: Open the magnetic covers on both sides and install two high-rate 18650 cells into iStick TC100W body. The device can be powered on/off by pressing the fire button five times.
The device can also be used with one high-rate 18650 cell installed, but the maximum output wattage can only be 75W instead of 100W when two high-rate 18650 cells are installed.

Vaping: Long press the fire button to take a puff.

Stealth on/off: Press the fire button and down button simultaneously when the device is powered on to switch between Stealth On and Stealth Off mode. In Stealth On mode, you can vape with the OLED screen off and you can press the fire button one time to see current setting.

Eleaf iStick TC100W Box Mod vape store

Adjustment buttons lock/unlock: Keep pressing up button and down button simultaneously for two seconds when the device is powered on, then the up and down buttons will be locked and the screen will display “Lock”.

Switch display mode: Keep pressing up button and down button simultaneously for two seconds when the device is powered off, the screen display will rotate 180 degrees.You can view the screen from two different angles through this operation.

Switch vaping modes: Long press the menu button to switch among VW, Bypass, TC-Ni, TC-Ti, TC-SS, TCR-M1, TCR-M2, TCR-M3 modes.

Adjust wattage: In TC-Ni/TC-Ti/TC-SS/TCR(M1,M2,M3) mode, the output wattage can be adjusted from 1W to 100W. Keep pressing the menu button and up button simultaneously without looseness to increase the wattage level. On the contrary, keep pressing the menu button and down button simultaneously without looseness to decrease the wattage level.

How to Charge
The battery power indicator on the screen of Eleaf iStick TC100W Box Mod will keep flashing when the remaining power of the 18650 cells is less than 10%.The 18650 cells can be charged in the iStick TC100W through USB port at the bottom of the device via 1A wall adapter or charged with a separate battery charger. If the 18650 cells are charged in the iStick TC100W, the battery indicator on the screen will keep flashing during charging and the screen will go out when fully charged.

It is recommended to charge the 18650 cells with a separate battery charger as it will take less time to give them a full charge.

No comments

Powered by Blogger.